All Categories
- Industrial LCD display
-
Industrial Products
- DC Servo Drive
- AC Servo Drive
- other
- Heidelberg
- FANUC
- IFM
- Meter
- CCD
- Membrane Keypad
- Film
- YOKOGAWA Module
- Card
- ABB
- MITSUBISHI
- FANUC
- KEYENCE
- BECKHOFF
- Honeywell
- HOLLYSYS
- FUJI servo drives
- HP
- solenoid valve
- thermostat
- Siemens adapter
- color oscilloscope
- Fujitsu connector
- CHELIC
- SMC
- CISCO Module
- INTEL
- Key board
- FAIRCHILD
- Motherboard
- Board
- Bearing
- other
- Control Panel
- Contactor
- Circuit
- OMRON
- Relay
- Controller
- Photoelectric Switch
- Photoelectric Sensor
- Original
- Fan
- Motor Driver
- Limit Switch
- Amplifier
- power supply
- LENZE
- Cable
- Encoder
- Sensor
- Transformer
- Fiber Optic Sensor
- Protection Relay
- Temperature Controller
- Proximity Switch
- Switch Sensor
- Siemens
- Industrial board
- HMI Touch Glass
-
HMI Full Machine Whole unit
- OMRON HMI Touch Panel
- Siemens HMI Touch Panel
- Mitsubishi HMI Touch Panel
- Allen-Bradley automation HMI Touch Panel
- DELTA HMI Touch Panel
- EVIEW DELTA HMI Touch Panel
- KINCO DELTA HMI Touch Panel
- HITECH HMI Touch Panel
- WEINTECK HMI Touch Panel
- TECVIEW HMI Touch Panel
- WEINVIEW HMI Touch Panel
- PRO-FACE HMI Touch Panel
- SIMATIC HMI Touch Panel
- AMPIRE HMI Touch Panel
- HEIDELBERG HMI Touch Panel
- PANASONIC HMI Touch Panel
- PATLITE HMI Touch Panel
- KYOCERA HMI Touch Panel
- KEYENCE HMI Touch Panel
- WEINVIEW HMI Touch Panel
- HITECH HMI Touch Panel
- FUJI HMI Touch Panel
- HAKKO HMI Touch Panel
- SCHNEIDER HMI Touch Panel
- SAMKOON touch panel
- other
- Module
- lcd inverter
- Membrane Keypad Switch
- Winni Touch Screens
- Frequency Inverter
- Servo Motor
- PLC
Recommended Products
Home » News
|
One,Phenomenon description:
The liquid crystal leakage liquid is sealed in the liquid crystal screen glass liquid crystal leakage phenomenon, the serious degree of the liquid leakage is different, the image character will not be normal (or completely unable) to display. Leakage is often divided into two types: one is damaged glass crack or rupture caused by leakage of liquid crystal; the glass is not damaged, but the LCD glass substrate two around the sealing resin damage caused by leakage of liquid crystal.
Two, cause:
1 glass damage caused by leakage:
The bad phenomenon of this kind of leakage is generally concentrated in the middle position of the non edge of the liquid crystal screen. It is basically caused by the external force, and most of them can see the obvious signs. At this point with the finger gently pressure leak liquid position, you can see the movement of the force movement traces of the liquid crystal has been the direction of movement (the following chart)
 2 glass sealing resin damage caused by leakage of liquid:
This undesirable phenomenon of leakage is often concentrated in the four edge of the LCD screen, the LCD is perfusion in the resin material for special will be between two pieces of glass around the seal, if there is a beverage, fruit juice, tea and acid corrosive liquid accidentally from the outside into the screen edge to soak, will make the sealing resin material the damaged and can not reach the sealing effect inside the liquid crystal into liquid leakage.
The following figure for coke down on the screen caused by the leakage of liquid  Three, daily protection
1 LCD monitor for a long time without the need to turn off the power or set the host for the power saving mode
2 to minimize the use of a longer period of time to use high brightness full white screen, the two points can be slowed down the tube aging, delay display service life
3, to maintain the storage and use of the environment clean, clean screen surface
4, away from high temperature and high humidity environment
5, is strictly prohibited to crush the screen surface
7, to avoid unnecessary vibration
8 do not disassemble
|
